Gxt Ferret 54 ENGINE DIAGNOSTIC CENTER Manuel d'utilisateur Page 100
- Page / 102
- Table des matières
- DEPANNAGE
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
E054-02 Printed in U.S.A.9-7
SAFETY PRECAUTIONS
Read All Instructions Before Using
The Engine Diagnostic Center
■ Always wear eye protection when testing vehicles. Be extra careful near
batteries and moving parts. Do not lay tools on a battery.
■ Battery gas is highly explosive.
a. If a battery explodes flush the acid away from persons skin with generous
amounts of water. Follow up with a neutralizing solution of baking soda
and then more water.
Treat clothing, vehicle parts, and equipment similarly. Any acid traces
inside equipment must be removed by generous rinsing. Dry equipment
and place in a warm 50°C (120°F) oven until thoroughly dry.
b. Never use a wrench on the ungrounded battery terminal until the
grounded one has been disconnected. Contact between the vehicle body
metal and the hot terminal can cause sparks to ignite gas or even weld
tools into a battery short circuit.
c. Keep the space around a battery well ventilated.
d. Do not make sparks or allow flames near batteries.
■ Before working on a vehicle set the brakes and block the wheels.
Beware of automatic parking brake releases.
■ Keep your work area well ventilated and free of exhaust. Engine exhaust
contains deadly poisons. Treat Gas Detector exhaust and drain hoses the
same as the vehicle tailpipe. Both give off deadly exhaust fumes.
■ Avoid electrical shocks caused by getting close to live ignition wires or
touching the coil TACH terminal. A person’s reaction near a running engine
can be more damaging than the shock.
■ Keep spark producing devices at least 0.5m (18”) above the floor to reduce
the hazard of igniting gasoline vapor.
■ Do not let test leads wind up in a moving fan or pulley. Route leads away.
■ Remove finger rings and metal wrist bands. They can short terminals and
become very hot from electric current.
- DIAGNOSTIC CENTER 1
- INTRODUCTION 5
- INSTALLING PAPER 8
- PROGRAM CARTRIDGES 9
- CLOCK / CALENDAR 9
- CONNECTIOCONNECTIONS 13
- Nippondenso 15
- COIL DRIVER MODULE 16
- ELUMINATOR 17
- Diagnostic Center Setup 18
- SAMPLE HOSE 19
- CALIBRATION GAS HOSE 20
- DRAIN HOSE 20
- EXHAUST HOSES 20
- ROAD TEST 21
- TEST KEYS / MENUS 24
- CONTROL KEYS 25
- Engine Setup 26
- Emissions Setup 26
- Program Cartridges 27
- Gas Detector Service 27
- CUSTOM PRINTOUT HEADER 28
- ENGINE TESTENGINE TESTING 29
- IGNITION SECONDARY — DIS 36
- Ω ÿÿ ÿΩ ÿÿ ÿπ ÿÿ ÿÿ 37
- Ω Ω ü ï ÿ π ÿ ÿ 38
- Ω ÿü ÿü 38
- Secondary 39
- HARD START — Distributor 40
- HARD START — Diesel 41
- Electronic Compression 42
- Power Contribution 43
- Power Balance 43
- Ignition 43
- Ω ü ÿ π Ω ï 44
- Ignition Secondary 45
- Power Balance Automatic 46
- Power Balance Manual 46
- DIS or Diesel 46
- Manual Suppression 47
- ELECTRICAL 48
- VOLT AMP METER 49
- AUXILIARY METER 50
- ZERO AMP PROBE 50
- O2 SENSOR TEST 52
- VACUUM / PRESSURE METER 52
- LOGIC TRACE SCOPE 53
- SOLENOID DUTY CYCLE 53
- Emissions 54
- Ignition Primary 55
- AUTOTEST - DISTRIBUTOR 58
- AUTOTEST - DIS 59
- TYPICAL REYPICAL READDINGS 61
- TYPICAL READINGS 62
- TYPICAL DIS READINGS 64
- FUEL INJECTORS 66
- Primary Amps 67
- O2 TEST 69
- O2 TEST with EMISSIONS 69
- EMISSIONS 70
- Data Recorder 71
- PRINTED REPORTS 72
- GAS THEOAS THEORY 73
- SAMPLING 74
- OR MORE DETAIL, REFER 75
- TESTING EMISSIONS 76
- INTAKE MANIFOLD LEAKS 78
- CATALYTIC CONVERTER 78
- OTHER TESTS 79
- COMBUSTION THEORY 80
- Stoichiometric Chart 81
- 3 WAY CATALYTIC CONVERTER 82
- UNDERSTANDING RESULTS 83
- MAINTENANCNCE 85
- MAINTENANCE 86
- CALIBRATE 87
- LEAK TEST 88
- OXYGEN SENSOR REPLACEMENT 89
- NOx SENSOR REPLACEMENT 89
- REPLACING THE FILTERS 90
- CAL & P.E.F 91
- MEASURE CAL GAS 91
- CLEANING THE SAMPLE HOSE 92
- CLEANING THE CENTER 92
- SERVICE INFORMATION 94
- TROUBLESHOOTING 95
- EMISSION PARTS 97
- CONSUMABLE PARTS 97
- SPECIFICATIONS 98
- Measurement Ranges 98
- SAFETY PRECAUTIONS 100
- WARRANTY 101
- EXTENDED SERVICE POLICY 101
- 1-800-647-5655 102
- 616-627-5664 102
- 616-627-2727 102
Produits connexes et manuels pour Équipement Gxt Ferret 54 ENGINE DIAGNOSTIC CENTER
(2 pages)© 2020, manymanuals.fr. Tous droits réservés | 0.775 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels