Gxt Ferret 54 ENGINE DIAGNOSTIC CENTER Manuel d'utilisateur télécharger pdf (Page 8)

Paper

Roll

Printer

Paper

Release

Button

PRINTER

The Diagnostic Center employs a 40 column

thermal dot matrix printer. Reports and

individual screens may be printed, and

results are formatted to provide easy

reference when comparing before and after

conditions.

The Paper Advance button advances blank

paper. A single press advances the paper 2

lines. Holding the button feeds the paper

continuously.

Cartridges

Optional

Optional

System

Paper

Advance

Button

1-3

INSTALLING PAPER

The outside surface of the paper is covered

with a heat sensitive coating. The paper must

be fed so that the coated outside surface is

fed upward, facing the back of the

compartment. Press the release buttons on

each side of the compartment to remove the

empty core. While holding the buttons, insert

the new roll until it is approximately centered.

Release the buttons and adjust the roll until

the holding pins snap into the core of the

paper roll. Make a clean square cut across

the end of the paper. Feed this end into the

opening formed by the plastic and metal

guides. Gently push the paper in 2 to 3 cm

(1 to 1.5") and press the Paper Advance

button until paper appears under the cutting

bar at the top of the compartment.

Use BLUE or BLACK thermal paper 80mm

(3.15") wide. The printer contrast can be

adjusted for paper with differing thermal

sensitivities. If characters are too dark or too

light, see Print Contrast in the

Diagnostic

Center Setup

section to select the contrast

setting that works best with the paper being

used.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 101 102

Commentaires sur ces manuels

Pas de commentaire