Gxt Ferret 31 Scan Tool Manuel d'utilisateur télécharger pdf (Page 8)

Readiness Status

Select Readiness Status from the

OBDII Session Menu and press

enter.

The status of all monitors, except the

comprehensive monitor is displayed.

The result of the comprehensive

monitor is displayed immediately

after the Scan Tool has successfully

connected to the vehicle controller.

A Value of “Pending” means that

particular monitor has not run. A

Value of “Done” means that particular

monitor has successfully completed

it’s test.

Accessing Additional Test Modes

Select Test Modes from the OBDII

Session Menu and press enter.

From the test mode screen you

can select O2 Sensor Tests, Non-

Continuous Tests, and Continuous

System Tests.

For additional information on each

test mode, consult the appropriate

section of the instruction manual.

Some vehicles do not support

additional test modes. If you select

one of the test modes listed here and

the Scan Tool does not report data within a few minutes, that test mode

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

Gxt Ferret 31 Scan Tool Manuel d'utilisateur Page 8