Gxt V055-01 Diagnostic Analyzer Manuel d'utilisateur télécharger pdf (Page 22)

Save Setup

This option allows the most frequently used engine

setup to be saved in permanent memory. The saved

setup will be loaded whenever power is applied to the

Diagnostic Center.

System Diagnostics

Built-in tests allow you to check the operation of various

test leads. Select the lead to be tested and follow the

screen instructions.

Scope Setup

The Scope Setup function refers to the two BNC connectors located on

the back of the analyzer. BNC-1 will always send out a Sync pulse that

is sensed by the Spark Pickup. BNC-2 will output Secondary Ignition from the KV input or the Primary

Amps from the Black Pickup. The choice is determine by the Scope Setup Software.

You may use either of the signals or both to drive a labscope. Below are a couple of samples of patterns

on different labscopes.

You may also use the BNC-1 signal to trigger the labscope. This will allow you to reference any other

signal to engine rpm.

Secondary Ignition Secondary Ignition Fuel Injection Current

on Labscope on Labscope on Labscope

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 28

Pas de commentaire

Gxt V055-01 Diagnostic Analyzer Manuel d'utilisateur Page 22