Gxt V055-01 Diagnostic Analyzer Manuel d'utilisateur télécharger pdf (Page 7)

Keys & Controls

Press the MENU key anytime you want access

to the main test menu.

MESSAGE

The MESSAGE key is active when the ﬂashing

message symbol '* is on the screen. Messages

may span several screens. Press the MESSAGE

key until all messages have been viewed, and the

original screen has been restored.

HELP

Press the HELP key when you want context

sensitive help.

Press PRINT to print the display contents to a printer.

Arrow Keys

Use the up and down arrow keys to change numbers or make a different selection.

The NEXT key is used to go on to the next step in a test or procedure or to act on an item that is selected.

In some cases the NEXT key will clear minimums or maximums and restart a measurement.

The setup Engine Setup screen automatically appears

after power is applied to the unit. You must program the

EngineLink with the proper information about the vehicle

to be tested. Use the up and down arrows to move the

cursor to your selection. Pressing NEXT will enter the

selection and move to the next menu.

Select the number of cylinders, and press NEXT. A new

screen will appear, offering a choice of ignition type.

Distributor ignitions will have a Separate Coil or an

Integral Coil, where the coil is inside the distributor

housing (like GM HEI). In some cases, as with many

Nippondenso ignitions, the Coil (-) wire is not accessible.

In that case, SELECT No Coil (-) Wire.

Non-Distributor ignitions include Diesel engines, DIS

Coil/Plug, and DIS Dbl End (double end or output) where

each coil ﬁres two plugs at the same time.

Select the ignition type, and press NEXT. Select 4 or

2 strokes, and select the ﬁring order. Choosing a ﬁring

order causes test data to be displayed in cylinder block

number sequence. If the default is accepted, e.g., 1 2 3

4, the results will be displayed in ﬁring order sequence.

Initial Setup

IgnitionLink LT ENGINE ANALYZER

HELP

NEXTNEXT

Material: 0.010 thk Polycarbonate, Matte Finish.

Acrylic Adhesive Backing Over All Except As Shown.

Print Subsurface as shown. Align Artworks to Targets.

Label Size: 12.0" x 9.0".

F055-01 Rev A

Sheet 1 of 6

F055-01 Rev A

F55 Front Panel Label

1 2 3 4 5 6 7 8 9 10 11 12 ... 27 28

Commentaires sur ces manuels

Pas de commentaire

Gxt V055-01 Diagnostic Analyzer Manuel d'utilisateur Page 7

Commentaires sur ces manuels

Produits connexes et manuels pour Équipement Gxt V055-01 Diagnostic Analyzer