Gxt V055-01 Diagnostic Analyzer Manuel d'utilisateur télécharger pdf (Page 23)

Printing

The EngineLink supports printing to a custom thermal printer. Connections for power and data are made

through the RJ-45 connector found on the back of the analyzer. Simply plug in the printer and press the

PRINT button on the front panel.

Individual test results or the autotest results can be printed.

Demonstration Mode

The EngineLink has a demonstration mode built in. If you are trying to demonstrate the unit in order to

make a sale, or you just want to get familiar with the screens without connecting to a car, the demonstration

mode will help. All the demonstration mode does is load data into the test screens. You do not actually

“run” a test in demo mode, you only see the results of the test.

To enter Demo Mode hold the Up Arrow button down as you apply power. If the analyzer says it remembers

a previous setup, press NEXT, then continue holding down the Up Arrow button. The screen will be blank

for a few seconds, then the screen will ﬁll with information. Let go of the UP Arrow button. When you

get the screen saying there is an error printing to the printer, press the NEXT button once, then hold it

down. After a few seconds the analyzer will beep rapidly 6 times. This is your indication that the demo

has loaded successfully. Press the MENU button and view any test you like.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28

Pas de commentaire

Gxt V055-01 Diagnostic Analyzer Manuel d'utilisateur Page 23