Gxt V016-01, Ferret 16 GasLink II 5-Gas Analyzer Manuel d'utilisateur télécharger pdf (Page 11)

RPM Source

Use the SELECT buttons to choose the RPM source, then press

the NEXT button. You will be returned to the analyzer setup screen.

Selecting Distributor or DIS requires that the RED Inductive Pickup

be connect around the sparkplug wire. For vehicles that do not

have spark plug wires use the No Spark Wire selection.

No Spark Wire RPM input

Use the SELECT buttons to choose the number of cylinders, then

press the NEXT button. Connect the Spark Pickup to the wire

that supplies battery power to the coil(s) or coil pack(s) to read

RPMs.

Fuel Type Selection

Use the SELECT button to select the fuel type used in the engine,

then press the NEXT button. You will be returned to the analyzer

setup screen. Selecting the proper fuel will ensure that the CO2,

AFR, and Lambda measurements are calculated properly.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 23 24

Pas de commentaire

Gxt V016-01, Ferret 16 GasLink II 5-Gas Analyzer Manuel d'utilisateur Page 11